Hello everyone! I'm new to Fanaleds, so help the newbie here :
I'm using the T500rs as a wheel base, and i attached the SRW-S1 wheel to it, but i use the usb cable of the SRW-S1 so i can assign functions/buttons. And also i have the SLI-PRO.
I use the SRW-S1 leds to show the rpm, and i use SLI-PRO to show gear and timing. I mapped the wheel knobs, the center and right knobs, to switch functions of the SLI-PRO(left and right, respectively), and the left knob to adjust SLI-PRO brightness.
PROBLEM: When playing GSC 2013, after a few laps(3 to 5), the SLI-PRO and the SRW-S1 rpm leds freezes. So I alt-tab to FANALEDS software, and after i click any button on the software takes about 10 seconds to work. It's like the FANALEDS freezes. I can close it clicking on exit, but it takes time to do it. Then I can open it again and the problem start after a few laps again.
Any help?
Thanks a lot!